Installation Dimensions
1a. New Installation
Choose the location for the dispenser on either side of the faucet. Prior to drilling, check for any obstructions below the sink, including any drains, sink bowl or water lines.
Mark the center of the desired spout location no more than 3.3” from edge of sink bowl. Drill a 1” diameter hole into the countertop. Then clean the counter surface at that location.
1b. If Replacing a Dispenser
Remove the existing components, both above and below the counter. Discard partially drained batteries.
Verify the size of the existing counter hole is between 15/16” and 1-1/8” in diameter and the center of the hole is no more than 3.3” away from the edge of the sink. Then clean the counter surface at that location. If the hole is larger than 1-1/8” please call GPXpress at 1-866-435-5647.
Installation
Step 2
Feed the wiring harness through the gasket. Slide the gasket onto the stem until it reaches the base of the unit and align it so it fits in the recess at the base of the spout.
Step 3
Insert spout assembly through the hole in the countertop and feed the spout cable through the wing nut. Thread the wing nut onto the stem and hand tighten until gasket is compressed and is tight against the countertop.
Step 4
Orient the motor assembly with the open area pointing toward the room for ease of inserting the refill. Move the spout cable out of the way while sliding the motor assembly onto the stem as far as possible.
Insert the locking clip until it clicks into place.
Step 5
Connect the spout cable in the stem to the matching cable from the motor assembly behind the motor assembly, being sure to align the arrows on the connectors before securing the connection
Install Battery Pack
*Hardware not included
Step 1
Secure the battery pack to the wall using screws, foam tape or other method appropriate to the type of wall.
Step 2
Insert the 4 D cell batteries into the front cover of the battery pack. Replace the battery pack cover by inserting the bottom edge and hand tighten the thumb screw.
Step 3
Connect the battery pack power cord to the motor assembly power cord.
Installation is complete.
