Wall Mounting Your Dispenser
Step 1
Position unit on wall so that the top is level.
NOTE: Recommended distance from bottom of dispenser to the floor is 42”-44”. ADA compliant when installed properly. ADA compliance for installation is the responsibility of the installer.
Step 2
Use key to open front cover and mark screw locations where indicated with circles.
Step 3
Secure unit to wall with four (4) anchored screws appropriate to the type of wall in locations previously marked.
Close dispenser. Installation is complete.
Installation with Mounting Bracket
Step 1
Position unit on wall so that the top is level. Use key to open front cover and mark screw hole locations where highlighted in blue.
NOTE: Recommended distance from bottom of dispenser to the floor is 42”-44”. ADA compliant when installed properly. ADA compliance for installation is the responsibility of the installer.
Step 1
Assemble two (2) mounting brackets (#54019 sold separately) by connecting the sides as shown.
For accessories or replacement components, please call: 1-866-HELLOGP (1-866-435-5647).
Step 3
Ensure that arrows on bracket are pointing up and the top is level. Peel film from the adhesive on the back side and with firm pressure, adhere the assembled mounting bracket to wall lining up keyhole slots with shaded areas previously marked.
Use four (4) anchored screws appropriate to the type of wall in the keyhole slots indicated to secure bracket.
Step 4
Fit dispenser onto brackets. Lock into place by gently pulling downward. Listen for a click indicating cabinet is properly secured.
Close cover. Installation is complete.
Push Button Install
Push Button Lock
Lock option that open when pushed. No key required to open dispenser.
Key Lock
Lock option that requires the key to open the dispenser
Step 1
Locate the lock on the top of the dispenser cover
Step 2
Push both sides of the push plate and remove it by sliding it out.
Step 3
Remove the key lock by gently pushing it out of the key hole on the cover.
Step 4
Add the push button lock by popping it into the key hole on the cover.
